personalenergylife.blogg.se - Epson stylus photo 1400 software for mac

#EPSON STYLUS PHOTO 1400 SOFTWARE FOR MAC INSTALL#

Close the cartridge lids and return the print head to the parked position, by pushing the ink change button again. If you think that the vent holes are blocked, poke a pin through the tab material, into the vent hole, to vent the cartridge). Make sure that the holes are open, and are not blocked with a little piece of vent tab or dried ink.

#EPSON STYLUS PHOTO 1400 SOFTWARE FOR MAC INSTALL#

Push the ink change button, and when the print head moves to the cartridge change position, remove the Epson cartridges and install the cartridges after you have peeled off the vent tabs (note: before putting the Piezography cartridges in your printer, look at the air vent holes that had been covered with the vent tabs.

Test the printer with Epson inks to verify that it functions perfectly, as described above.

A full manual for Piezography can be downloaded with the free Piezography Community Edition.

This software has quickly become a defacto utility for anyone wanting to properly color manage their printing workflow. Additionally, Piezography on the Mac requires the use of Print-Tool. We provide our own guides to our suggested use of QuadToneRIP, so that you can get the best results from that product. Installation instructions and support of that software is provided by the manufacturers of those software. Most Piezography systems depend upon the QuadtoneRIP software with which to control the ink shades. You must refer to the shade placement chart provided here on this document. Whether you use refillable cartridges, CIS, or pre-filled cartridges (available outside the USA), the placement of the shades of Piezography ink are critical and not arbitrary. If you lost your refillable cartridge instructions, please go to our main support page to view the cartridge instructions.

If you are installing user refillable cartridges, please refer to the installation instructions provided with the refillable cartridges. If you are installing a Continuous Ink System (CIS), please refer to the installation instructions provided with the CIS.

Use these procedures to convert your color printer to a Piezography printer.